Category: Topography

Analogs of the Christian Bible’s Epic of Noah’s Ark

Leave a comment

In London, England in 2014, Dr. Irving Finkel, one of, if not the worlds most foremost authoritive upon cuneiform writing, published a book entitled “The Ark Before Noah” which states that a 3700 year old Sumerian tablet translated by Finkel depicts the Christian biblical story of Noah and the flood which drowned the world. This tablet is at the very least 1000 years older than that of the Biblical epic. In the Christina Bible, Noah is warned of a cataclysmic flood by God. A similar story exists in ancient Indian Vedic texts in which King Manu was forewarned by Lord Vishnu in the form a fish, of a great flood impending, with Manu constructing a large boat and ultimately surviving. In the Babylonian poem the Epic of Gilgamesh, the protagonist Utnapishtim (pronounced “ut-nah-pish-tim”) is advised of an impending flood by the god Enki (pronounced “en-kee”). In ancient Aztec culture, a sacred male and female couple hide within a hollow tree with corn while holding steady as the deluge of a great flood envelops the Earth. Ancient Celtic, Norse, and Chinese mythology also account similar stories in which a great flood occurs and only some survive. The common denominator between all of these stories is intervention by a force which knew ahead of time of the impending cataclysm

The Causation of the Colors of the Aurora Borealis

Leave a comment

The colors of the aurora borealis are layered with violet at the bottom, green in the middle, and red at the top, which signifies the structure of the atmosphere. Just as different chemicals create different colored flames (e.g. propane always producing a blue flame etc.), so too do photons bouncing around in the atmosphere off of different elements present. Nitrogen glows violet in a band at the bottom and oxygen glows green and red, creating a curtain 400 kilometers in length

The Carrington Event of 1859

Leave a comment

On September 1st and September 2nd in 1859 the Carrington Event occurred. English Astronomer Richard Carrington was reviewing an image of the sun when he noticed a bright flash upon the imagery. Carrington did not know what this anomaly was but soon learned first hand as approximately 20 hours later, chaos ensued. 200,000 kilometers of telegraph wire across the world collapsed, plugged in electrical items began to arc and produce power even when unplugged, batteries recharged without a power source, compass needles went haywire, and the Aurora Borealis could be viewed all across the world, in places which would never normally bare witness to such an event (e.g. Cuba and India etc.). This incident will inevitably occur again which is why the U.S. government is constructing the Thirty Meter Telescope upon Mauna Kea at an altitude of 10,000‘ and the reason the Parker Solar Probe was sent to the sun in 2018. Mauna Kea means “white mountain” in ʻŌlelo Hawaiʻi, the Hawaiian language. The rational of the U.S. government is that the Carrington Event affected the world greatly when electricity was in its infancy, therefore how much greater would it affect the modern world with the knowledge that many objects during the modern day are connected to the internet and/or are electrical in some capacity. The Carrington Event is the first mass coronal ejection reported in history

The Reason Icebergs Sink Ships

1 Comment

The reason that an iceberg is able to cut into the side hull of a ship (e.g. Titanic etc.) or any other marine vessel is dual fold. The first reason is because steel becomes more brittle, the colder it gets. Steel created during the early 20th century was not tempered as steel is during the modern day. The second reason is because of inertia, weight, and force. An iceberg can slash through steel the same way a tree can rip through a vehicle that has hit it. An iceberg is a large, immovable object, so whether the hull is comprised of wood or titanium, the ice will always win out as it has more inertia and mass. To provide a frame of reference, bone is incredibly strong and tensile, however if a brick which is harmless while at rest, slams down from a height above the arm, the force it imparts is enough to break said bone

The Fallacy of Moss Always Growing Upon the North Side of Trees

1 Comment

Moss does not only grow on the north side of trees, as it is commonly believed by many. Moss typically grows on the north side but this rule only applies in the northern hemisphere. In the southern hemisphere, moss mostly grows on the south side of trees. The reason for this inversion is that in the northern hemisphere, because of the tilt of the Earth on its axis, the sun almost always appears to be a little south of directly overhead. That’s why rooms with windows facing south are brighter than rooms with windows facing north. This is important for moss because the north sides of trees within the northern hemisphere are shadier and therefore wetter. The south sides of trees get more sunlight, so water evaporates faster there

The Difference between QR Codes and Bar Codes

3 Comments

The primary difference between QR code’s and barcodes is that a barcode must be read horizontally, has a maximum storage capacity of 12 – 43 characters (e.g. universal product code etc.), and can store data in one dimension, whilst a QR code is capable of being read horizontally and vertically, has a maximum storage capacity of 4000 – 7089 characters, and can store data in two dimensions as a matrix bar code. Additionally, a QR code can be 10x smaller than a bar code and still be legible and a QR code can be read if damaged or parts missing. The term “QR code” is an abbreviation for “quick response code”

How Ocean Wind Turbines Produce Electrical Energy

2 Comments

Wind turbines run upon a simple engineering principle which is that of wind causing the blades to turn which rotates a shift within the turbine, with this shaft producing energy for the electrical generator. This electrical energy is pumped downward, 300’ below the water surface, and into cables buried below the seabed which connect to offshore substations which then connect to onshore power stations and finally residential homes and industrial and commercial buildings. Ocean wind turbines are typically 600’ high in altitude, with spinning fiberglass blades which are approximately 240’ long, with each blade weighing up to 30 tonnes. Because of this immense size, measurements (e.g. angle of blades etc.) are crucial during the construction phase to maximize efficiency and energy output. A single revolution of a wind turbine can generate enough electricity to power an entire family home for 24 hours

Tudor Period Mining and Metal Smelting

Leave a comment

During the Tudor period, lead was utilized to build roofs and windows because it was easily mailable and resistive to corrosion. Farmers would mine for lead during the summer months when their crops did not need tending to in order to generate additional income. Mining during the summer months could earn an extra £5.00 which equates to £25,000 as of 2012 when accounting for inflation. Entire families often worked within the mines because 50 barrels worth of ore and soil would be extracted per day to meet the quota of what was required to be profitable. Smelting involved the use of white coal which is effectively dried wood from a kiln and was always setup upon windy hilltops or mountains because the wind would cause the fire blaze with more intensity therefore reaching higher overall temperatures. The best wood to make white coal is oak. Kilns must be airtight, so gaps were filled with clay. Knowing a kiln to be airtight was easily verifiable by searching for smoke as if smoke only came out of only the front entrance, the kiln was considered airtight. Ore was smashed into small pieces to help it smelt more rapidly which yielded approximately an 80% return upon investment. Metals were then refined using a secondary kiln, and smelted to remove any ash or impurities. The first burn removes ore from the rock, and the second burn removes impurities with the main impurity being sulphur. Molds were constructed using sand and wood to create divots which allowed the ore to be molded into blocks much the same as a modern day bar of gold. The sand gives the mold an indentation which archeologists use to identify Medieval bars of smelted ore

The Financial Cost of a Hollywood Walk of Fame Star

Leave a comment

As of 2023, the cost a celebrity must incur to have their name and profession immortalized upon the Hollywood Walk of Fame is $55,000. This fee is stated to pay for the installation of the star as well as its maintenance (e.g. sweeping and cleaning throughout the year etc.)

How Holograms Work

Leave a comment

Holograms work by taking a single laser beam and splitting it into 2 parts, with the primary beam falling upon the object being photographed which then bounces away and falls onto a specialized screen, and the secondary beam falling directly upon the screen. The mixing of these beams creates a complex interface pattern containing a three dimensional image of the original object which can be captured on specialized film. By flashing another laser beam through the screen, the image of the original object suddenly becomes holographic. The term “holograph” is derived from the ancient Greek terms ”holo” which means “whole” and “graphos” which means “written”. The main issue with holographic technology is that unlike traditional visual media which needs to flash a minimum of 30 frames per second, scattering the image into pixels, a three dimensional holograph must also flash 30 frames per second, but of every angle to create depth of field, and the amount of data required far exceeds that of a traditional television photograph or video, even exceeding the capability of the internet until recently in 2014 when internet speeds reached 1 gigabyte per second